P0300TA.pdf 데이터시트 (총 5 페이지) - 파일 다운로드 P0300TA 데이타시트 다운로드

No Preview Available !

PXXXXTA SERIES
Thyristor Surge Suppressors (TSS) Data Sheet
Description
DO-214AC Thyristor solid state protection thyristor protect
telecommunications equipment such as modems, line cards,
fax machines, and other CPE.
P Series devices are used to enable equipment to meet
various regulatory requirements including GR 1089, ITU
K.20, K.21 and K.45, IEC 60950, UL 60950, and TIA-968
(formerly known as FCC Part 68).
Features
Compared to surge suppression using other technologies, P Series devices offer absolute surge protection
regardless of the surge current available and the rate of applied voltage (dv/dt). P Series devices:
Cannot be damaged by voltage
Eliminate hysteresis and heat dissipation typically found with clamping devices
Eliminate voltage overshoot caused by fast-rising transients
Are non-degenerative
Will not fatigue
Have low capacitance, making them ideal for high-speed transmission equipment
Meets MSL level 1, per J-STD-020
Safety certification: UL: E244458
Electrical Parameters
Parameter
VDRM
VS
VT
IDRM
IS
IT
IH
CO
IPP
ITSM
di/dt
Definition
Peak Off-state Voltage – maximum voltage that can be applied while maintaining off state
Switching Voltage – maximum voltage prior to switching to on state
On-state Voltage – maximum voltage measured at rated on-state current
Leakage Current – maximum peak off-state current measured at VDRM
Switching Current – maximum current required to switch to on state
On-state Current – maximum rated continuous on-state current
Holding Current – minimum current required to maintain on state
Off-state Capacitance – typical capacitance measured in off state
Peak Pulse Current – maximum rated peak impulse current
Peak One-cycle Surge Current – maximum rated one-cycle AC current
Rate of Rise of Current – maximum rated value of the acceptable rate of rise in current
over time
Revision29-Jul-16
www.brightking.com

No Preview Available !

Electrical Characteristics
PXXXXTA SERIES
Part
Number
VDRM
(V)
VS
(V)
VT
(V)
IDRM
(μA)
IS
(mA)
IT
(A)
IH
(mA)
CO
(pF)
Marking
P0080TA 6 25 4
5 800 2.2 50 50 P008A
P0300TA 25 40
4
5 800 2.2 50 70 P03A
P0640TA 58 77
4
5 800 2.2 150 50 P06A
P0720TA 65 88
4
5 800 2.2 150 50 P07A
P0900TA 75 98
4
5 800 2.2 150 45 P09A
P1100TA
90 130
4
5 800 2.2 150 45 P11A
P1300TA
120 160
4
5 800 2.2 150 45 P13A
P1500TA
140 180
4
5 800 2.2 150 40 P15A
P1800TA
170 220
4
5 800 2.2 150 40 P18A
P2300TA
190 260
4
5 800 2.2 150 35 P23A
P2600TA
220 300
4
5 800 2.2 150 35 P26A
P3100TA
275 350
4
5 800 2.2 150 30 P31A
P3500TA
320 400
4
5 800 2.2 150 30 P35A
Notes:
·All measurements are made at an ambient temperature of 25. IPP applies to -40through +85temperature range.
·Off-state capacitance(CO) is measured at 1 MHz with a 2V bias and is typical value.
·For surge ratings, see table below.
Surge Ratings
Series
A
IPP
2×10μs
(A)
150
IPP
8×20μs
(A)
150
IPP
10×160μs
(A)
90
IPP
10×560μs
(A)
50
IPP
10×1000μs
(A)
45
ITSM
60Hz
(A)
20
di/dt
(A/μs)
500
Thermal Considerations
Package DO-214AC/SMA
Symbol
TJ
TS
RθJA
Parameter
Operating Junction Temperature
Storage Temperature Range
Junction to Ambient on printed circuit
Value
-40 to +150
-40 to +150
120
Unit
/W
Revision29-Jul-16
www.brightking.com

No Preview Available !

Part Number Code and Marking
PXXXXTA SERIES
Characteristics Curves
Figure 1. V-I Characteristics
Figure 2. tr × td Pulse Wave-form
Figure 3. Normalized Vs Change versus Junction
Temperature
Figure 4. Normalized DC Holding Current versus
Case Temperature
Revision29-Jul-16
www.brightking.com