Each channel of the timer can be used as “8-bit timer x 2 channels” or “16-bit timer x 1 channel”.
Built-in timer function, PWC function, PWM function, capture function and square wave-form output
Count clock: 7 internal clocks and external clock can be selected.
PWM mode or one-shot mode can be selected.
Counter operating clock: Eight selectable clock sources
Support for external trigger start
8/16-bit PPG Each channel of the PPG can be used as “8-bit PPG x 2 channels” or “16-bit PPG x 1 channel”.
(1 channel) Counter operating clock: Eight selectable clock sources
Count clock : Four selectable clock sources (125 ms, 250 ms, 500 ms, or 1 s)
Counter value can be set from 0 to 63. (Capable of counting for 1 minute when selecting clock
source 1 second and setting counter value to 60)
Four selectable interval times (125 ms, 250 ms, 500 ms, or 1 s)
Interrupt by edge detection (rising, falling, or both
Can be used to recover from standby modes.
Supports automatic programming, Embedded AlgorithmTM *4
A flag indicating completion of the algorithm
Number of write/erase cycles (Minimum) : 10000 times
Flash memory Data retention time : 20 years
Erase can be performed on each block
Block protection with external programming voltage
Flash Security Feature for protecting the content of the Flash
Standby mode Sleep, stop, watch (for dual clock product), and timebase timer
*1 : For ROM capacity and RAM capacity, refer to “■ MEMORY LINEUP”.
*2 : For details of option, refer to “■ MASK OPTION”.
*3 : Specify clock mode when ordering MASK ROM.
*4 : Embedded Algorithm is a trade mark of Advanced Micro Devices Inc.
Note : Part number of evaluation product in MB95130MB series is MB95FV100D-103.
When using it, the MCU board (MB2146-303A) is required.