YB1230.pdf 데이터시트 (총 11 페이지) - 파일 다운로드 YB1230 데이타시트 다운로드

No Preview Available !

YB1230
600mA, Low-Noise LDO Regulator
„ Description
The YB1230 is a series of low-noise, low
dropout (LDO) linear regulators with 2.0%
output voltage accuracy. The YB1230
regulators achieve a low 500mV dropout at
600mA load current of 3.1V output and are
available in voltages ranging from 1.8V to
3.1 V with 0.1 V per step (custom voltage is
considerable at request).
The YB1230 regulators are optimized to
work with low-ESR and low cost ceramic
capacitors, reducing the amount of board
space critical in hand-held devices. The
YB1230 requires only 2.2μF output
capacitor for stability with any load and
consumes less than 1μA in shutdown
mode.
Built-in thermal shutdown and short-circuit
protect offer secure protection against fault
operation. The YB1230 regulators are
available in SOT-23 / SOT-25 / SOT-89
packages.
„ Features
„ 2.0% Accuracy Output Voltage
„ Output Voltage Range 1.8V ~ 3.1V
„ Low-Noise Low-Drop-Out
„ Stable with 2.2μF Ceramic Capacitor for
Any Load
„ Typical Output Current : 600mA
„ Low Quiescent Current : ~90μA
„ 500mV Dropout at 600mA Load (3.1V)
„ Only Need Input and Output Capacitors
„ Power Saving Shutdown Mode (<1μA)
„ Thermal Protection Shutdown
„ Built-In Internal Soft-Start
„ Output Short-Circuit Current Limit
Protection
„ Green package (RoHS) available
„ Applications
„ PDA, Palmtops and Notebook Computers
„ DSC, Handset Camera Modules
„ PCMCIA Cards, PC Cameras
„ USB Based Portable Devices (MP3, PMP)
„ GSM/GPRS/3G RF Transceiver Modules
„ Wireless LANs
„ Bluetooth Portable Radios
Typical Application Circuit
Figure 1-1: SOT-25 Application Circuit
Figure 1-2: SOT-23/SOT-89 Application Circuit
YB1230 Rev.1.6
www.yobon.com.tw
1

No Preview Available !

Pin Configuration
YB1230
600mA, Low-Noise LDO Regulator
Figure 2: Pin Configuration
Pin Description
Table 1
Name
Description
VIN Unregulated input supply. Bypass with a capacitor to GND.
GND
EN
Ground pin.
Pull high to enable the regulator.
VOUT Regulated output voltage. Bypass with a capacitor to GND.
YB1230 Rev.1.6
www.yobon.com.tw
2

No Preview Available !

Ordering Information
YB1230
600mA, Low-Noise LDO Regulator
Marking Information
Absolute Maximum Ratings (Note 1)
Supply Voltage............................ -0.3V to 6V
Output Voltage ................ -0.3V to (VIN+0.3V)
Output Short-Circuit Duration..............Infinite
Junction Temperature Range............ +150
Storage Temperature Range...... -65to +150
Lead Temperature............................. +250
Recommended Operating Conditions
(Note 2)
Input Supply Voltage............... 2.0V to 5.5V
Operating Temperature........-40to +85
Thermal In formation (Note 3)
Thermal Resistance (SOT-23/25, θJA) ... 280/W
Thermal Resistance (SOT-89, θJA)......... 180/W
Internal Power Dissipation (SOT-23/25, PD) . 0.4W
Internal Power Dissipation (SOT-89, PD)..... 0.55W
Note:
1. Exceeding these ratings may damage the device.
2. The device is not guaranteed to function outside of its operating conditions.
3. θJA is measured in free air at TA = 25on a low effective thermal conductivity board.
YB1230 Rev.1.6
www.yobon.com.tw
3

No Preview Available !

YB1230
600mA, Low-Noise LDO Regulator
Electrical Characteristics
Table 2 VIN = ( VOUT + 1V ), CIN = COUT = 2.2μF, VEN = VIN, TA=25°C, unless otherwise noted.
Description
Symbol
Test Conditions
MIN TYP MAX Units
Input Voltage Range
Output Voltage
Output Voltage Accuracy
Output Current Limit
Dropout Voltage (Note 1)
Ground Current
Line Regulation
Load Regulation
Shutdown Supply Current
Ripple Rejection (PSRR)
Shutdown Exit Delay (Note 2)
EN Logic Low Level
EN Logic High Level
EN Input Bias Current
Thermal Shutdown
Thermal Hysteresis
VIN 2.0 5.5
VOUT Predefined
1.8 3.1
ΔVOUT IOUT = 10mA
-2.0 +2.0
ISC Short-Circuit Output
380
VOUT = 3.2V, IOUT = 600mA
500
VOUT = 3.0V, IOUT = 600mA
520
VDROP VOUT = 2.5V, IOUT = 600mA
600
VOUT = 2.0V, IOUT = 600mA
750
VOUT = 1.8V, IOUT = 600mA
850
IG Iground = IIN - IOUT
90 150
ΔVLINE VIN=(VOUT+1V) to 5.5V, IOUT=10mA
0.3
ΔVLOAD IOUT = 1mA to 600mA
2
ISD EN = 0V
1
f = 100Hz, IOUT = 10mA
56
PSRR f = 1KHz, IOUT = 10mA
56
f = 10KHz, IOUT = 10mA
45
VOUT = 2.8V, Rload = 9 ohm
40 100
VIL VIN = 2.0V to 5.5V
0.4
VIH VIN = 2.0V to 5.5V
1.5 VIN
IBEN VIN = EN = VOUT +1V
0.01
TSD Shutdown Temperature
160
THYS VOUT = 1.8V, IOUT = 100mA
20
V
V
%
mA
mV
μA
%/V
%
μA
dB
μs
V
V
μA
°C
°C
Note :
1. The drop out voltage varies depending on output voltage selection. Dropout is defined as VIN – VOUT when
VOUT is 100mV below nominal VOUT where VIN = VOUT + 1V for nominal VOUT.
2. Time needed for VOUT to reach 90% of final value.
YB1230 Rev.1.6
www.yobon.com.tw
4

No Preview Available !

YB1230
600mA, Low-Noise LDO Regulator
Typical Performance Characteristics
VIN = ( VOUT + 1V ), CIN = COUT = 2.2μF, VEN = VIN, TA=25°C, unless otherwise noted.
Dropout Voltage vs. Output Voltage
Dropout Voltage vs. Load Current
Ground Current vs. Input Voltage
Dropout Voltage vs. Temperature
Load Transient Response (1)
Load Transient Response (2)
YB1230 Rev.1.6
www.yobon.com.tw
5