3KP Transient Voltage Suppressor Diode Series
The 3KP series is designed to protect voltage sensitive components from high voltage, high
energy transients. They have excellent clamping capability, high surge capability, low zener
impedance and fast response time. The 3KP series is supplied in YINT Semiconductor’s
exclusive,cost-effective,highly reliable and is ideally suited for use in communication
systems, automotive, numerical controls , process controls, medical equipment, business
machines, power supplies and many other industrial/consumer
P600 glass passivated chip junction
Polarity:Color band denoted positive end (cathode) except Bidirectional.
Typical failure mode is short from over-specified voltage or current
Fast response time: typically less than 1.0ps from 0 Volts to BV min.
High Temperature soldering:260°C/10 seconds at terminals.
Solder dip 275 °C max. 10 s, per JESD 22-B106
Use in sensitive electronics
protection against voltage transients
induced by inductive load switching
and lighting on ICs, MOSFET,
signal lines of sensor units for
consumer, computer, industrial,
automotive, and telecommunication.
Electrical Characteristics (@ TA = 25°C Unless Otherwise Noted)
Peak pulse power dissipation with a 10/1000 μs waveform
Peak pulse current with a 10/1000 μs waveform
IFSM See next table
Power dissipation on infinite heat sink at TL= 75 °C
PD 7 Watts
Peak forward surge current 8.3 ms single half sine-wave
Instantaneous forward voltage at 100 A for Unidirectional only
Operating junction and storage temperature range
-55 to +175
(1)Non-repetitive current pulse, per fig. 6 and derated above TA = 25 °C per fig. 2
(2)Measured 8.3 ms single half sine-wave or equivalent square wave, duty cycle = 4 pulses per minute maximum