B116XAN01.0.pdf 데이터시트 (총 30 페이지) - 파일 다운로드 B116XAN01.0 데이타시트 다운로드

No Preview Available !

Product Specification
AU OPTRONICS CORPORATION
( V ) Preliminary Specifications
( ) Final Specifications
Module
Model Name
Note
11.6” 16:9 Color TFT-LCD
with LED Backlight design
B116XAN01.0 (H/W:2A)
LED Backlight with New Digitizer Design
Customer
Date
Approved by
Date
Checked &
Approved by
Date
Kevin KH Shen 10/05/2012
Prepared by
Erica YT Lin 10/05/2012
Note: This Specification is subject to change
without notice.
DMPBU Marketing Division
AU Optronics corporation
B116XAN01.0 Document Version : 0.3
1 of 39

No Preview Available !

Product Specification
AU OPTRONICS CORPORATION
Record of Revision
Version and Date Page
0.1 07/27/2012
0.2 08/28/2012 6
0.3 10/05/2012 4
32&33
Old description
Contrast ratio 800typ
New Description
1st version
Update Chromaticity
Contrast ratio 800 min
Update 2D drawing
Remark
B116XAN01.0 Document Version : 0.3
2 of 39

No Preview Available !

Product Specification
AU OPTRONICS CORPORATION
Contents
1. Handling Precautions
1) Since front polarizer is easily damaged, pay attention not to scratch it.
2) Be sure to turn off power supply when inserting or disconnecting from input connector.
3) Wipe off water drop immediately. Long contact with water may cause discoloration or
spots.
4) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
5) Since the panel is made of glass, it may break or crack if dropped or bumped on hard
surface.
6) Since CMOS LSI is used in this module, take care of static electricity and insure human
earth when handling.
7) Do not open nor modify the Module Assembly.
8) Do not press the reflector sheet at the back of the module to any directions.
9) At the insertion or removal of the Signal Interface Connector, be sure not to rotate nor
tilt the Interface Connector of the TFT Module.
11)After installation of the TFT Module into an enclosure (Notebook PC Bezel, for
example), do not twist nor bend the TFT Module even momentary. At designing the
enclosure, it should be taken into consideration that no bending/twisting forces are
applied to the TFT Module from outside. Otherwise the TFT Module may be damaged.
12)Small amount of materials having no flammability grade is used in the LCD module. The LCD
module should be supplied by power complied with requirements of Limited Power Source
(IEC60950 or UL1950), or be applied exemption.
13)Disconnecting power supply before handling LCD modules, it can prevent electric shock, DO
NOT TOUCH the electrode parts, cables, connectors and LED circuit part of TFT module that
a LED light bar build in as a light source of back light unit. It can prevent electrostic
breakdown.
B116XAN01.0 Document Version : 0.3
3 of 39