ISL6296A.pdf 데이터시트 (총 2 페이지) - 파일 다운로드 ISL6296A 데이타시트 다운로드

No Preview Available !

DATASHEET
To request the full datasheet, please visit www.intersil.com/products/isl6296a
FlexiHash™ For Battery Authentication
ISL6296A
The ISL6296A is a highly cost-effective fixed-secret hash engine
based on Intersil’s FlexiHash™ technology. The device’s
authentication is achieved through a challenge response
scheme, which is customized for low-cost applications where
cloning via eavesdropping without knowledge of the device’s
secret code is not economically viable. When used for its
intended applications, the ISL6296A offers the same level of
effectiveness as other significantly more expensive high
maintenance monetary-grade hash algorithm and
authentication schemes.
The ISL6296A has a wide operating voltage range and is suitable
for direct powering from a 1-cell Li-ion/Li-Poly or a 3-cell series
NiMH battery pack. The ISL6296A can also be powered by the
XSD bus when the bus pull-up voltage is 3.3V or higher. The device
connects directly to the cell terminals of a battery pack and
includes on-chip voltage regulation circuit, POR and a noncrystal
based oscillator for bus timing reference.
Communication with the host is achieved through a single-wire
XSD interface (a light-weight subset of Intersil’s ISD bus
interface). The XSD bus is compatible for use with serial ports
offered by all 8250 compatible UART’s or a single GPIO (General
Purpose Input and Output) pin of a microprocessor.
A clone prevention solution utilizing the ISL6296A offers
safety and revenue protection at the lowest cost and power
and is suitable for protection against after-market
replacement for a wide variety of low-cost applications.
Related Literature
AN1167, “Implementing XSD Host Using a GPIO”
AN1788, “ISL6296A Evaluation Kit”
• UG019, “ISL6296ARU-EVZ Evaluation Board User Guide”
• AN1166, “FlexiHash Engine Algorithm”
Features
• Challenge-response based authentication scheme using
32-bit challenge code and 8-bit authentication code
• Fast and flexible authentication process. Multipass
authentication can be used to achieve the highest security
level if necessary
• 16x8 OTP ROM stores up to three sets of 32-bit host selectable
secrets with additional programmable memory for storage of
up to 48 bits of ID code and/or pack information
• FlexiHash engine uses two sets of 32-bit secrets for
authentication code generation
• Nonunique mapping of the secret key to an 8-bit
authentication code maximizes hacking difficulty due to
need for exhaustive key search (superior to SHA-1)
• Supports 1-cell Li-ion/Li-Poly and 3-cell series NiMH battery
packs (2.6V ~ 4.8V operation), or powered by the XSD bus
• XSD single-wire host bus interface communicates with all
8250-compatible UART’s or a single GPIO. Supports CRC on
read data and transfer bit-rate up to 23kbps
• True “Zero Power” sleep mode - automatically entered after
a bus inactivity time-out period
• 5 Ld SOT-23, 8 Ld TDFN and 8 Ld µTQFN packages
• -25°C to +85°C operating temperature range
• Pb-free (RoHS compliant)
Applications
• Battery pack authentication
• Printer cartridges
• Add-on accessories
• Other nonmonetary authentication applications
PACK+
XSD
R1
330Ω XSD ISL6296A VDD
R2
4.7kΩ
PROTECTION
D1
5.1V
PACK-
VSS
C1
0.1µF
FIGURE 1. TYPICAL APPLICATION WITH THE ISL6296A POWERED BY THE BATTERY
May 26, 2015
FN6567.5
PACK+
XSD
R1
330Ω XSD ISL6296A VDD
PROTECTION
D1
5.1V
VSS
C1
0.1µF
PACK-
FIGURE 2. TYPICAL APPLICATION WITH THE ISL6296A POWERED BY THE XSD BUS
1 CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 1-888-468-3774 | Copyright Intersil Americas LLC 2007-2010, 2014, 2015. All Rights Reserved
Intersil (and design) and FlexiHash are trademarks owned by Intersil Corporation or one of its subsidiaries.
All other trademarks mentioned are the property of their respective owners.

No Preview Available !

ISL6296A
For additional products, see www.intersil.com/en/products.html
Intersil products are manufactured, assembled and tested utilizing ISO9001 quality systems as noted
in the quality certifications found at www.intersil.com/en/support/qualandreliability.html
Intersil products are sold by description only. Intersil Corporation reserves the right to make changes in circuit design, software and/or specifications at any time
without notice. Accordingly, the reader is cautioned to verify that data sheets are current before placing orders. Information furnished by Intersil is believed to be
accurate and reliable. However, no responsibility is assumed by Intersil or its subsidiaries for its use; nor for any infringements of patents or other rights of third
parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of Intersil or its subsidiaries.
For information regarding Intersil Corporation and its products, see www.intersil.com
Submit Document Feedback
2
FN6567.5
May 26, 2015