Maker : Hirose Electric
Part No. : W.FL-2LP-04N2-A

  Datasheet PDF : W.FL-2LP-04N2-A.pdf
  Cross Reference : W.FL-2LP-04N2-A Cross Reference
  Buy Component : W.FL-2LP-04N2-A Find Stock and Price

Shortcut : W.FL-2LP-04N2-A  W.FL-2LP-04N2-A-L 

Product Information

NEW Ultra Small Surface Mount Coaxial Connectors – 1.4mm Mated Height W.FL Series – Further downsizing of FL series in response to the market needs. Occupied Mounting Area 2.0 2.0 sFeatures 1. Mounting area of only 3.4mm 2 q Mated Height Comparison(With U.FL series) 2. The board mounted receptacle weights only 5.6 mg 3. Accepts high frequency transmission of DC to 6GHz (MAX2.0) (MAX2.5) U.FL-LP-040 U.FL-LP-066 U.FL-LP(V)-040 W.FL-LP-040 (MAX1.55) 1.4 1.9 2.4 U.FL Series 2.85 Cable (MAX1.55) Dia. 0.81 W.FL-R-SMT-1 Receptacle 4. Receptacle supplied on tape-and-reel for 4. placement on the board with automatic equipment 5. Plugs are terminated with ultra-fine Teflon® 4. insulated coaxial cables 6. Un-mating with a simple tool W.FL Series sApplications Mobile phones, Wireless LAN, Bluetooth protocol devices, PDA, GPS, electronic measuring instruments and any application requiring high frequency transmission over coaxial line, where space is limited. Plug * Teflon is a registered trademark of DuPont. 1.4 2004.4 1 sProduct Specifications Nominal characteristic 50 ohms Operating temperature range -40ç to +90ç (Relative humidity 90% max.) DC to 6GHz Operating humidity -40ç to +70ç (Relative humidity 90% max.) Ratings impedance Frequency range sMaterials and Finishes Item 1. Contact resistance 2. Insulation resistance 3. Withstanding voltage 4. V.S.W.R.(Note) Specification Center: 20m ohms max. Outside: 10m ohms max. 500M ohms min., 100V DC 200V AC / 1 minute 1.3 max. (Up to 3GHz) 1.35 max. (3 to 6GHz) Note:V.S.W.R. Measurement System Note:Measured as shown on the block diagram below. Note:Test connection and measurement setup. Network Analyzer Test Set Test Port Test Port Cable D.U.T Termination Note1:Cable type connector measurements. With SMA conversion adapters mated with W.FL plug at each end of the 100cm long ultra-fine coaxial cable. Note2:Board type connector measurements. Mounted on a 50 ohms glass epoxy board. Measurements were conducted with SMA conversion adapters attached. sMaterial/Finishes Part Plug Component Shell Insulator Socket center contact Shell Material Phosphor bronze PBT Phosphor bronze Phosphor bronze LCP Brass Finish/Remarks Silver plated Black, UL94V-0 Gold plated Silver plated Black, UL94V-0 Gold plated Receptacle Insulator Pin center contact sPlug 2 2.85 Plugs can be ordered only terminated to the cable. 2 1.15 sHow to Specify Cable Assembly Double-ended cable assembly Single-ended cable assembly *** L(mm) L(mm) q Ordering Information q Standard tolerances for (L)** (L)(mm) *L=35 to 200 L=200 to 500 L=500 to 1000 W.FL -- 2LP -- 04N [ ] -- A -- (L) 1 2 3 4 5 Standard Tolerance (mm) ±4 ±8 ±12 ±1.5% of (L) 1 Series name 2 Assembly type 3 Cable type 4 Cable color 5 Total length (mm) L=1000 / W.FL LP2: Single ended 2LP: Double ended 04N: 0.81mm dia. ultra-fine coaxial cable 1: White, 2: Black Length (L) *Minimum available length (L) is 35mm **Contact nearest HRS representative if different tolerances are required. ***Contact Nearest HRS representative if one end requires preparation. sReceptacle BRecommended PCB Mounting Pattern 0.85 0.3 0.25 0.5 1.3 1.7 2 2.6 1.4 1.3 0.3 1.7 2 SIGNAL TERMINAL 1.3 0.65 GND GND No conductive traces in this area SIGNAL TERMINAL PAD Recommended screen thickness: 0.1mm to 0.12mm Part Number W.FL-R-SMT-1(10) CL No. 331-0482-6-10 Packaging Reel packaging (2000 pieces/reel) Weight / EA 5.6 mg 1.5 3 sConversion Adapters q SMA Conversion Adapter (W.FL side jack – SMA side plug) (10.3) 8HEX W.FL SMA Note:Used for performance measurements only. The W.FL mating side has lower retention force than the regular product when mated to the corresponding part. Part No. HRMP-W.FLJ CL No. 311-0367-3 q SMA Conversion Adapter (W.FL side plug – SMA side jack) 13.8 6 SMA Ø6.35 ( 4.05 ) 5.6 1/4-36UNS-2A W.FL Note:Used for performance measurements only. The W.FL mating side has lower retention force than the regular pr...

Link URL